Banks 42790 Monster-Ram 4" Intake Elbow Kit for 2007.5-2018 Ram 6.7L Cummins

Description

Monster-Ram improves airflow from the intercooler.
Flows 1008 cfm (77.01 lbs/min) compared to Stock’s measly 432 cfm (33.00 lbs/min)
. Raises boost without increasing backpressure at the turbine. Result: a more responsive, power efficient engine. Up to four 1/8 inch
NPT
ports for flexibility! The top two
NPT
ports are positioned to allow for proper atomization directly into the center of the air mass while preventing wall wetting. Accommodates stock mounting points including Temperature and Pressure sensors, wire harness and dipstick tube.
Key Features
Improves airflow from the intercooler
Raises boost without increasing turbine drivepressure
Larger & less restrictive than stock intake
Quicker throttle response
Outflows stock by 133%
4 inch
CNC
machined inlet
Includes Fuel Line, 4 to 3.5 inch Hump Hose and all necessary hardware
Four 1/8 inch
NPT
ports
Backed by a 5-year warranty
Optional Banks Heater Delete adds an additional half pound of boost
This is a Race only product. Not Emissions Compliant. Race Tuning Required
Requires Banks Boost Tubes for Installation – Part Number Varies by Year
At Banks Power, just enough is never enough when it comes to engine airflow.
Maximum power, performance and efficiency
are the ultimate goals, but to make it all happen the engine has to breathe freely and without needless restrictions. Finding ways to pump your engine full of cooler, denser air has always been the key.
Our High-Ram intakes have always whipped the competition. Our new Monster-Ram flat-out destroys it
. Utilizing the latest in electronic computational fluid-dynamic technology, tested on the flow bench as well as on the dyno, and finally proven in the real world where the rubber meets the road, Monster-Ram is a beast that only Banks could have unleashed.
A simple, direct-replacement casting, Monster-Ram is instant power, performance and acceleration gratification. The factory inlet is cramped and angular compared to Banks’ larger, streamlined cast-metal Monster-Ram. It’s the perfect upgrade whether you’re just starting out or working to build a serious, purpose-built race machine. And with up to four ports for water/methanol/propane/nitrous injection (or pressure/temp. sensors), the sky’s the limit for performance expandability. Monster-Ram is
CNC
ported as well as the optional Banks Billet Intake Grid Heater Delete spacer.
Note:
For Race Use Only. Emissions equipment must be removed and race tuning is required. Does not fit with some high mount Dual CP3 Injection Pumps .
**THIS ITEM CANNOT BE SHIPPED TO CALIFORNIA**